New video on The eTextile Lounge youTube channel!.
Arduino Code can be uploaded to ATtiny45 using the Arduino as ISP Tutorial
/*FIVE LED Blink Slow in Sequence*/
/*Arduino Uno v.1.0.3 as ISP for Atmel ATtiny45 internal 8MHz clock*/
/*14 Ocotber 2014*/
/*lynne bruning for The eTextile Lounge*/
/*http://lbruning.com/etextilelounge*/
int led1 = 0;
int led2 = 1;
int led3 = 2;
int led4 = 3;
int led5 = 4;
// the setup routine runs once when you press reset:
void setup()
// initialize the digital pin as an output.
{
pinMode(led1, OUTPUT);
pinMode(led2, OUTPUT);
pinMode(led3, OUTPUT);
pinMode(led4, OUTPUT);
pinMode(led5, OUTPUT);
}
// the loop routine runs over and over again forever:
void loop()
{
digitalWrite(led1, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(led1, LOW); // turn the LED off (LOW is the voltage level)
delay(1000); // wait for a second
digitalWrite(led2, HIGH);
delay(1000);
digitalWrite(led2, LOW);
delay(1000);
digitalWrite(led3, HIGH);
delay(1000);
digitalWrite(led3, LOW);
delay(1000);
digitalWrite(led4, HIGH);
delay(1000);
digitalWrite(led4, LOW);
delay(1000);
digitalWrite(led5, HIGH);
delay(1000);
digitalWrite(led5, LOW);
delay(1000);
}
When you upload the code you will receive the following information on the Arduino window:
Binary sketch size: 1,014 bytes (of a 4,096 byte maximum)
Error Message – Ignore it.
avrdude: please define PAGEL and BS2 signals in the configuration file for part ATtiny45
avrdude: please define PAGEL and BS2 signals in the configuration file for part ATtiny45
